Page 1
HW-07LN03 HW-09LN03 HW-12LN03 No.0010515219 Downloaded from AC-Manual.com Manuals...
Page 2
9-12 13-14 Downloaded from AC-Manual.com Manuals...
Page 3
Front panel Air inlet (indoor side) Machine body Air outlet (indoor side) Air inlet (outdoor side) Display panel Power plug Air filter (inside) MODE FAN,COOL,DEHNM. :HIGH or LOW. SWING ENERGY SAVER POWER Downloaded from AC-Manual.com Manuals...
Page 4
POWER MODE FAN,COOL,DEHNM. SPEED ENERGY SAVER SWING Downloaded from AC-Manual.com Manuals...
Page 5
COOL Press POWER button 2. Select operation mode Press MODE button. For each press, operation mode changes as follows: COOL DEHUM When the COOL display light bright, A/C will be working under the cooling function. SPEED POWER at outlet Downloaded from AC-Manual.com Manuals...
Page 6
POWER 2. Select operation mode Press MODE button. For each press, operation mode changes as follows: COOL DEHUM When the DEHUM display light bright,A/C will be working under the dehumidify function. If you need to only remove the moisture press the Dehnmid button. Change air flow direction if necessary, SPEED Air conditioner is running under displayed fan speed.
Page 7
POWER 2. Select operation mode Press MODE button. For each press, operation mode changes as follows: COOL DEHUM When the FAN display light bright,A/C will be working under the fan function. POWER Downloaded from AC-Manual.com Manuals...
ENERGY SAVER operation POWER 2. Select operation mode Press MODE button. For each press, operation mode changes as follows: COOL DEHUM Then select COOL operation When the FAN display light bright,A/C will be working under the fan function. Saving energy function only can be used when A/C working on cooling condition.
Page 9
cool Press "On"of remote controller or "TIMER" of control panel, Press "Off"of remote controller or "TIMER"of control panel, Downloaded from AC-Manual.com Manuals...
Page 10
The compressor must stands by for 3 minutes before it is restareed after shut down,There is no 3-minute protection with power on for the first time. Power failure resume(please set and apply as necessary) If sudden power failure occurs, the unit will resume original operation when power is supplied again. Note: When sudden power failure happens during unit operation in power failure resume mode, if the air conditioner is not desired for use in a long period, please shut off the power supply in case that the...
Page 11
" CLOSE"position, the vent door opens to allow air, smoke or odors to be expelled from the room; " OPEN"position, the vent door is closed and the air inside the room is circulated and conditioned. CLOSE OPEN Downloaded from AC-Manual.com Manuals...
Page 13
Disposal of the condensed water Generally there are two methods available on disposal of the condensed water: 1. Block the bottom plate hole of the conditioner with rubber lid, install outlet pipe fitting on the back hole and let the condensing water flow from the back hole of the conditioner. (See Fig.1 ) In this method, the accumulated condensed water in the bottom plate is hit by the fan onto the heat exchanger, and evaporated and blown out from the machine.