Sanyo PLC-XP21N Service page 17

Lamp ass'yMplacement
^ RESET THE LAMP REPLACEMENT MON!TOR T)MER.
NOTE: Do not reset the LAMP REPLACEMENT MONtTOR TtMER, except after the [amp is rep)aced.
1. Press the MENU BUTTON and the MA)N MENU D)SPLAY diabg box wiii appear.
2. Press the POiNT LEFT/RtGHT BUTTON(s) to seiect SETTiNG and press the SELECT BUTTON. Another
diafog box SETDNG DJSPLAYwiii appear.
3. Press the POiNT DOWN BUTTON and a red arrow wiii appear.
4. Move the arrow by pressing the PO)NT UP/DOWN BUTTON(s) to se)ect Lamp age and then press the
SELECT BUTTON. When you reset the tamp repface monitor, "tamp repiace monitor reset?" is displayed for
confirmation.
5. Move the arrow to Yes and then press the SELECT BUTTON, "OK?" is disptayed for confirmation. Move the
arrow to Yes and then press the SELECT BUTTON, the iamp roptace monitor is reset.
6. Move the arrow to No and then press the SELECT BUTTON. The famp replace monitor is not reset.
7. To quit the MENU, move the arrow to Quit and then press the SELECT BUTTON.
MAIN MENU DISPLAY
't't'
' ! ' ) '
Engtish
Btue back
Disptay
SETDNG
DfSPLAY
Reverse T/B
Reverse L/R
B^<B Sp)itwipe
Power
management
Recommendation
Should the air fitter become ciogged
with dust partlctes, [t wiH reduce the
cooling fan's effectiveness and may
resuit in internal heat buiid up and
short iamp iife. We recommend clean-
ing the air fitter after the projection
tamp is reptaced.
Refer to AIR FtLTER CARE AND
CLEANING on the Owner's Manual.
US8
Remote controi Mode 1
Quit
Lamp rep)ace monitor
Reset ?
No
NOTE ;
HOW TO CHECK THE LAMP )LLUM)NAT)ON T)ME
F
/
With the projector in operating mode, press and hotd the PO!NT UP
button tor 20 seconds, service mode disptay witt appear on the
screen.
tttumination time=Data Vaiue
Exampte titumination time is 13 hours.'--"
Press the "POWER ON OFF" button to quit the service mode.
Lamp iHumination time
Data no. Data
', ^ ^ [1^ f^]
A !————————}—
Data Va!ue .^'
—17