Electrolux EHG 30215 User Manual page 24

24 electrolux
Electrical connection
• Ground the appliance according to safety
precautions.
• Make sure that the rated voltage and type
of power on the rating plate agree with the
voltage and the power of the local power
supply.
• This appliance is supplied with a mains ca-
ble. It has to be supply with a correct plug,
able to support the load marked on the
identification plate. The plug has to be fit-
ted in a correct socket.
• Any electrical component must be instal-
led or replaced by the Service Force Cen-
tre technician or qualified service person-
nel.
• Always use a correctly installed shock-
proof socket.
• Make sure that there is an access to the
mains plug after installation.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
• The appliance must not be connected with
an extension cable, an adapter or a multi-
ple connection (risk of fire). Check that the
Assembly
min. 650 mm
Possibilities for insertion
Kitchen unit with door
The panel installed below the hob must be
easy to remove and let an easy access in
case a technical assistance intervention is
necessary.
ground connection is in conformity with
the standard and regulations force.
• The power cable must be placed in such
a way that it does not touch any hot part.
• Connect the appliance to the mains with a
device that lets to disconnect the appli-
ance from the mains at all poles with a
contact opening width of minimum 3 mm,
eg. automatic line protecting cut-out, earth
leakage trips or fuse.
• None of a parts of the connection cable
can not get a temperature 90°C. The blue
neutral cable must be connected to the
terminal block label with "N". The brown (or
black) phase cable (fitted in the terminal
block contact marked with "L") must al-
ways be connected to the live phase.
Replacement of the connection cable
To replace the connection cable use only
H05V2V2-F T90 type. Make sure that the ca-
ble section is applicable to the voltage and
the working temperature. The yellow/green
earth wire must be approximately 2 cm. lon-
ger than the brown (or black) phase wire.
490 mm
270 mm
A - supplied seal
B - supplied bracket
A
B