General Maintenance; Disposal Of Ashes; Inspect The Burn Pot; Cleaning Glass Door - Napoleon NPS45 Maintenance & Cleaning

32

9.0 GENERAL mAINTENANCE

9.1 dAILY (WhENEvER USING ThE hEATER)
9.1.1 OPEN mAIN vIEWING dOOR
The front of the heater becomes very hot during operation. Let the heater cool completely before
A. Open the side doors on either side of
the heater.
B. On the right side of the heater are two
latches. Release the latches by pulling
the rear handle forward and
disengaging the hook from the door
frame. Swing open the viewing door.

9.1.2 dISPOSAL OF AShES

Ashes should be placed in a metal container with a tight fitting lid. The container should be placed on a non-
combustible floor, well away from combustible materials, pending final disposal. If ashes are disposed of by
burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders are
thoroughly cooled.

9.1.3 INSPECT ThE BURN POT

When burning, the flames should be bright orange with embers jumping from the burn
pot. If not see "MAKE SURE PELLETS ARE NOT PILING UP" or "CLEANING THE
BURNPOT" sections.

9.1.4 CLEANING GLASS dOOR

If the glass is not kept clean permanent discolouration and / or blemishes
may result. Normal operation of your pellet heater will produce a build-up on
the glass that should be wiped off daily. However, poor quality pellets or
extended burning on the low setting will cause the glass to "smoke up"
faster.
Refer to "REPLACEMENT PARTS" section to find out what this product is
equipped with and the thickness of the glass. Use only replacement glass
available from your Authorized dealer.
DO NOT CLEAN GLASS WHEN HOT!
If necessary, clean the glass with a soft cloth or paper towel. You could use "wood stove" glass cleaner to remove heavy
build-up.
Do not operate the heater with broken glass, as leakage of flue gases may result.

9.1.5 CARE OF PLATEd PARTS

If the appliance is equipped with plated parts, you must clean fingerprints or other marks from the plated surfaces before
operating the appliance for the first time. Use a glass cleaner or vinegar and towel to clean. If not cleaned properly before
operating for the first time, the marks can cause permanent blemishes on the plating. After the plating is cured, the
fingerprints and oils will not affect the finish and little maintenance is required, just wipe clean as needed.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room temperature but this
can be improved if the assembly is warmed, using a hair dryer or similar heat source.
TP - mAIN vIEWING dOOR_PEllET
TP - dISPOSAl OF AShES_PEllET
TP - INSPECT bURN POT_PEllET
TP - ClEANING GlASS dOOR
TP - CARE OF PlATEd PARTS
W415-0702 / 10.30.08
WARNING
!
conducting service.
fIGure 9.1.1a
fIGure 9.1.3
fIGure 9.1.1b
Side
Door
Latch