Table of Contents
Advertisement
Keystone Save
This option enables you to save your current keystone settings.
Saving your change once affects all sources. The changes are saved
when you turn off the projector.
Lens Memory
This function applies the stored lens shift, focus, and zoom adjust-
ment values to the selected signal.
The function performs a setting that enables or disables the "Adjust
(Source)" - "Lens Memory" functions of the menu. (See page E-33
for details of use)
• On -- Enables the lens memory function and applies the stored shift, fo-
cus, and zoom setting values to the selected signal.
• Off -- Disables the lens memory function so that there will be no stored
shift, focus, and zoom setting values for specific signals.
NOTE: The shift, focus, and zoom adjustment values can be stored regard-
less of whether or not the lens memory function is enabled, but they will be
values for all signals.
NOTE: In the Link mode the Lens Memory feature is not available.
User Name
Type in your desired name using the INPUT keys on the remote
control.
Select one character at a time with the INPUT buttons 1 through
10(0) and by moving the cursor with the SELECT button. The user
name must be 18 characters or less.
Only after completely finishing the selection of the characters, press
ENTER.
[Page 5]
Communication Speed
This feature sets the baud rate of the PC CONTROL connector (Mini
D-Sub 9 Pin).
It supports data rates from 4800 to 38400 bps.
The default is 38400 bps. Select the appropriate baud rate for your
equipment to be connected.
Projector ID
Each projector needs its own unique addresses when used in serial
communication mode. You can choose one of 64 unique address
using the spin box. First select Enable. Keep pressing increases the
number.
To make your setting available, select OK.
Default Source Select
You can set the projector to default to any one of its inputs each time
the projector is turned on.
Last .............. Sets the projector to default to the previous or last active in-
put each time the projector is turned on.
Select ........... Displays the selected source input every time the projector is
started up. Select an input from the pull-down menu.
Link Mode
This feature is used for multiple projector connection using RGB
Digital Input/Output connectors. The master projector is set to Master.
The other slave projectors are set to Slave. When not using Link mode,
set to Standalone. See page E-13 for setting up for triple or double
stacking in link mode.
Switcher Control
This feature sets the projector in communication with the NEC ISS-
6020 Switchers.
Stand Alone ................ Use the projector in stand alone operation.
SW 1 Level .................. Use the projector with one Switcher. (not available
SW 2 Level .................. Use the projector with two or more Switchers. (not
When changing this setting, the confirmation message will appear. If
you want to restart your projector, select Yes; if not, select No.
NOTE: This setting becomes effective only after the projector is restarted.
E – 37
in Link mode)
available in Link mode)
Advertisement
Table of Contents
