DFI blood-iron G41-T33 User Manual page 23

Front Panel Connectors
Parallel
HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET SW - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-BTN - Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1
(POS - Power On Suspend) state, it will blink every second. When the system is
in the S3 (STR - Suspend To RAM) state, it will blink every 4 seconds.
Pin
N. C. 1
HDD-LED
3
5
RESET SW
7
9
N. C.
11
Pin Assignment
N. C. PWR-LED
PWR-BTN
HDD Power
Signal
Ground
RST Signal
Key
N. C.
English
PWR-BTN
PWR-LED
12
2
11
1
HDD-LED
RESET-SW
Pin Pin Assignment
2
LED Power
4 LED Power
6
Signal
8 Signal
10
Ground
12 Key
E
23