Panasonic PV-GS19 Operating Instructions Manual page 56

Installing Video Stream Driver
Install this when your OS is Windows XP SP1 or
later, or Windows 2000 SP4 or later. (When your OS
is Windows XP SP2 or later, installing Video Stream
Driver is not needed.) Video Stream Driver must be
installed when you connect the Camcorder to the PC
with the USB Cable and use MotionDV STUDIO.
DirectX 9.0b is installed in your PC if it is not installed
beforehand.
• When DirectX 9.0b is installed, applications
supported by previous versions of DirectX may not
run. In this case, consult the manufacturers of the
applications disabled.
1
Insert the CD-ROM into the personal
computer's CD-ROM drive.
• Quit all applications.
• The [Setup Menu] screen appears.
2
Click [Video Stream Driver].
• The set up program starts running.
3
For Windows XP users:
Depending on your system environment,
installation of "DirectX 9.0b" may be
required. Click [Yes] and continue with
installation.
• After "DirectX 9.0b" is installed, the computer
will restart.
• Do not remove the CD-ROM.
• Installation may take a little while.
4
Finish installation by following the
on-screen instructions.
• Click [Next] and proceed with installation.
• After completing the installation, Click [Finish].
5
After the Video Stream Driver is installed,
please restart your computer.
Installation of MotionDV STUDIO
1
Insert the supplied CD-ROM into the
personal computer's CD-ROM drive.
• Quit all applications.
• The [Setup Menu] screen appears.
2
Click the [MotionDV STUDIO].
56
With a PC
3
Click [Next].
• After reading the displayed contents, please
carry out the installation according to
instructions.
4
Select the Video system.
• The [Readme] screen is displayed. Please
carefully read the displayed contents and close
the [Readme] screen.
5
After the completion of setup, click on
[Finish].
• Sample data is installed concurrently with the
MotionDV STUDIO software.
6
Click [Finish] when the [Restarting
Windows] dialog appears.
• Reboot the computer to finish installing
MotionDV STUDIO.
To start MotionDV STUDIO
If you wish to capture data from a tape, set the
Camcorder to Tape Playback Mode and insert the
tape. If you wish to capture images from the lens
of the Camcorder, set the Camcorder to the Tape
Recording Mode and remove the tape and the card.
With USB (supplied)
OS:
Windows XP SP1 or later
Windows 2000 SP4 or later
• The personal computer should be compatible with
USB 2.0 Hi-Speed.