Power Supply - Gigaset SL930A Manual

Connect the base to the telephone network and the mains

power supply

2
3
¤
Insert the phone cable into the right-hand/lower connection socket
base until it clicks into place.
¤
Insert the power cable from the power adapter into the connection socket
¤
Push both cables into the appropriate cable channels
¤
Place the cover in the notches on the back of the base
¤
First connect the power adapter
u
The power adapter must always be connected, as the phone will not operate
without a power supply.
u
Use only the supplied power adapter and phone cord. The pin connections on
telephone cables may vary .
Connect the charging cradle
2
1
3
4
and then the phone jack
4
1
3
5
4
3
.
3a
¤
Connect the flat plug to the charging
cradle
1
¤
Plug the power adapter into the power
socket
2
If you have to remove the plug from the
charging cradle again:
¤
First disconnect the power adapter from
the mains power supply.
¤
Then press the release button
disconnect the plug
Getting started
3a
at the rear of the
1
2
.
(not if mounting on the wall).
5
.
.
.
.
4
3
and
7