Specifications; Questions And Answers; Base Station Power Consumption - Gigaset A490 Manual

Specifications

Recommended batteries
Technology:
(NiMH)
Size:
Voltage:
Capacity:
We recommend the following types of bat-
tery:
◆
GP 550/700 mAh
◆
Yuasa Phone 700/800 mAh
◆
Peacebay 550/650 mAh
◆
Corun Ni-MH AAAJ650 (650 mAh)
◆
Highpower HFR-44AAAJ650 (650 mAh)
(Valid at the time of going to press)
The handset is supplied with recom-
mended batteries.

Base station power consumption

In standby mode
– Handset in base station
– Handset outside base station
During a call
General specifications
DECT standard
WDCT standard
Range
Operation time (DECT
version)
– Talk time
– Standby time
Operation time
(WDCT version)
– Talk time
– Standby time
Base station power
supply
Environmental con-
ditions in operation
*) country-specific
Service (Customer Care)
We offer you support that is fast and tai-
lored to your specific needs!
Our Online Support on the Internet:
www.gigaset.com/service
Nickel-metal-hydride
AAA (Micro, HR03)
1.2 V
650 mAh
approx. 1.3 W
approx. 0.8 W
approx. 1.0 W
is supported*
is supported*
up to 300 m outdoors
up to 50 m indoors
up to 12 hours
up to 177hours
up to 6 hours
up to 144 hours
100/240 V~, 50 Hz
+5 °C to +45 °C, 20% to
75% relative humidity
17
For more information on aftersales service,
please refer to your local warranty card.
In some countries repair and replace serv-
ices are impossible where the products are
not sold through our authorised dealers.

Questions and answers

If you have any queries about the use of
your telephone, visit our website at
www.gigaset.com/service
for 24-hour support. The table below con-
tains a list of common problems and possi-
ble solutions.
Problem Cause
Nothing The hand-
appears in set is not
the display. switched
on.
The batter-
ies are flat.
No wireless The hand-
connection set is out-
to the base side the
station, range of
Base search the base
flashes in station.
the display.
The base
station is
not turned
on.
No wireless The hand-
connection set is not
to the base registered
station,
Register
HS flashes
in the dis-
play.
You cannot The phone
hear a cord sup-
ringer/dial- plied has
ling tone not been
from the used or
fixed line has been
network. replaced
by a new
cord with
the wrong
jack con-
nections.
Error tone The sys-
sounds after tem PIN
system PIN you have
prompt. entered is
PIN forgot- incorrect.
ten.
Solution
a
Press the end call
key for approx.
5 seconds or place the
handset in the base
station.
Charge or replace the
batteries.
Move the handset
closer to the base
station.
Check the mains con-
¢
nector on the base sta-
tion page 6.
¢
Register the handset
page 14.
Please always use the
phone cord supplied or
ensure that the
pin connections are
correct when purchas-
ing from a retailer:
3-4 assignment of
telephone leads/
EURO CTR37.
Reset the system PIN to
the default 0000 using
¢
the software
reset page 16.
All settings are reset.
All lists are deleted.