Table of Contents
Advertisement
6.2.2. View video using IP address
View the live video on a web page using your IP device and its IP address. To have the correct IP
address ready and use it on a web page:
1. Convert a MAC address to an IP address or check the IP address on the IPAdminTool.
(The MAC address is attached on the side or bottom of the device.)
MAC address = 00‐13‐23‐01‐14‐B1 → IP address = 192.168.20.177
2. Open a web browser and enter the IP address of the device.
3. Click Continue to this website on the Security Certificate Alert page.
4. Click pop‐up blocked and install the ActiveX control. You need to install the ActiveX for displaying the
images.
5. Wait for a few seconds while the web page loads. The live video is displayed.
6.3. Reset
1. While the device is in use, press and hold the Reset button.
2. Release the Reset button after 3 seconds.
3. Wait for the system to reboot.
6.4. Factory Default
1. Disconnect the power supply from the device.
2. Connect the power to the device with the Reset button pressed and held.
3. Release the Reset button after 5 seconds.
4. Wait for the system to reboot.
The factory default settings can be inferred as follows:
IP address:
Network mask:
Gateway:
User ID:
Password:
the Hexadecimal number to Decimal number.
192.168.xx.yy
255.255.0.0
192.168.0.1
root
pass
NM‐IP4500
21
Advertisement
Table of Contents
