D
SCREW
(M3.0)
F
COVER
COVER LOCK
The camera may fall off the ceiling even after the proper installation and
!
mounting. To prevent any accident, make sure the ceiling is firm and stable
enough to support the camera. If any reinforcement is needed, consult with your
Caution
safety personnel and proceed with the installation.
4.1. Setting the Image Attribute
You can set the image attribute of camera through the webpage.
The menu of image attribute can be seen under Setup > Video & Audio > Video‐in > Attribute Setting.
Brightness, contrast, hue, saturation and sharpness can be adjusted.
4.2.Operating the OSD Menu
To operate the OSD of camera; refer to the "OSD Menu Control Manual" in the SDK.
COVER
HOLE
E
LOCK HOLDER.1
10°
LOCK HOLDER.2
6. Make the wires go through the square hole.
7. Insert mount holder and twist the camera
counterclockwise.
8. Fix the camera by driving a screw on lock
holder1 and 2.
9. Install the cover by inserting cover lock and
twisting clockwise.
NM‐IP4500
12