Setting The Time For "Screen Wiper - NEC PlasmaSync 50MP2 User Manual

The 2nd line of the "WORKING TIME":
→
0M ↔ 3M ↔ 6M ↔ 9M ↔ ... ↔ 57M
The 1st line of the "WAITING TIME":
→
0H ↔1H ↔ 2H ↔ 3H ↔ ... ↔ 12H
The 2nd line of the "WAITING TIME":
→
0M ↔ 3M ↔ 6M ↔ 9M ↔ ... ↔ 57M
6. Once the setting is completed...
Press the EXIT button several times to return to the
main menu.
To delete the main menu, press the EXIT button once
more.
Information
Setting the time
WORKING TIME
Set the length of time the "INVERSE/WT" mode lasts.
When the WORKING TIME is set to "ON", the
"INVERSE/WT" mode stays in the on state.
WAITING TIME
Set the length of time until the "INVERSE/WT" mode
starts.
* The "WORKING TIME" and "WAITING TIME" can
be set for up to 12 hours and 45 minutes in units of 3
minutes.
To select "ON" for the "WORKING TIME"...
Set the hours of the WORKING TIME to 0H and the
minutes to 0M. "ON" will be displayed.

Setting the time for "SCREEN WIPER"

Set the "SCREEN WIPER" operation time, "WAITING
←
TIME", and "SPEED".
Example: Setting so that the SCREEN WIPER mode
←
starts in 30 minutes and proceeds for one and a half
hours.
←
Perform Steps 1-2 on Page 32, then:
3. Use the L and M buttons to select "SCREEN WIPER",
4. Press the PROCEED button.
5. Adjust the time and speed using the
34
then use the and buttons to select "ON".
L O N G L I F E
PLE
ORBITER
INVERSE
SCREEN WIPER
SEL. PROCEED OK
The "SCREEN WIPER" screen appears.
S C R E E N W I P E R
WORKING TIME
SPEED
SEL. ADJ.
and the L and M buttons.
The mode switches as follows each time the
button is pressed.
S C R E E N W I P E R
WORKING TIME
WAITING TIME
SPEED
SEL. ADJ.
The 1st line of the "WORKING TIME":
→
ON or 0H ↔ 1H ↔ 2H ↔ 3H ↔ ... ↔ 12H
* The "WORKING TIME" (minutes) and "WAITING
TIME" cannot be set when the "WORKING TIME"
is "ON".
: AUTO
: OFF
: OFF
: ON
EXIT RETURN
: ON
: 1
EXIT RETURN
and buttons
and
: 1H
: 30M
: 0H
: 30M
: 1
EXIT RETURN
←