Resetting Your Router Back To Factory Settings; Frequently Asked Questions - Sapido RB-1602 Quick Installation Manual

23

Resetting Your Router back to Factory Settings :

Note : This will erase all of your configuration settings.
To restore the router to factory default settings. Please do the following.
1.Power on SAPIDO router, and wait till the Wireless/WPS light is lit.
2.Press the reset button on the back of the router with a pencil or paper clip, and hold it down for
10 seconds,
until the status light blinks 3-4 times, then release.
3.You should see the Wireless/WPS light flash. Once it stays lit (and green), the router is finished
being reset.

Frequently Asked Questions

1. Why can't I login SAPIDO router?
(1) Please make sure your connection is right. Your computer should connect to the LAN port
of SAPIDO router.
(2) Confirm the browser you used is Microsoft Internet Explorer, and type the IP 192.168.1.1.
Enter the default username and password: admin. If it is wrong, please reset your router
back to factory settings.
2. How to encrypt the SAPIDO router?
Login SAPIDO Router and choose "One Button Setup". Select your encryption type in Wireless
Setup or Extended Wireless Setup of the bottom. WPA2 is recommended. Please enter at least 8
characters/numbers.If your computer is not supported WPA2, you can select WEP and enter 10
numbers. Then, click "Finish" to complete setup.