Configuration; Logging Into Your Router; Connecting This Router To A Cable/Dsl Modem - Sapido RB-1602 Quick Installation Manual

Configuration

Logging Into Your Router :

Enter the router IP address (defaults below) into your browser and hit "Enter".
Router Mode : 192.168.1.1
Access Point & WiFi Access Point Mode : 192.168.1.254
Enter Login Information (default below) and click "Login".
Username : admin
Password : admin

Connecting this Router to a Cable/DSL Modem :

Switch the operation mode to "R".
1. Open IE browser, type IP 192.168.1.1(P.1), or open
"My Network Place", and click SAPIDO_RB-1632(P2).
192.168.1.1
(P1)
3. Select "One Button Setup"(P4) on the left menu.
4. Select "WAN Interface" is Ethernet Port. Select your "WAN Access Type" according to your Internet source, and
enter the username/password. Then, you can start to setup the wireless encryption.
5. After the setting is finished, you should see a "change successful" page with countdown. When the countdown
is completed, your wireless network and security will be active, and you should be able to login immediately with
the new password. However, if an error message shows up, please refresh the page and it will go back to the
entering page. Afterwards, you can access Internet.
It can be configured without Internet.
2. Fill in default Username and Password to login(P3).
SAPIDO_RB-1632
(P2
admin
admin
(P3)
(P4)
8