Specifications - Makita LH1040 Instruction Manual

59-2. Brush holder cap

SPECIFICATIONS

Model
Blade diameter
Blade body thickness
Riving knife thickness
Hole diameter
For all countries other than European countries
For European countries
Max. Cutting capacities (H x W) with blade 260 mm in diameter in the miter saw mode
Max. Cutting capacities at 90°in the table saw (bench saw mode)
-1
No load speed (min )
Table size (W x L)
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come
to a complete stop.
･
When using the tool in the miter saw
mode, secure the top table at the
topmost position so that the saw blade
never protrudes from the top surface of
the top table.
･
Do not place hand or fingers close to
the blade.
･
For your safety, remove the chips,
small pieces, etc. from the table top
before operation.
Bevel angle
0°
45° (left)
69 mm x 130 mm
93 mm x 95 mm
35 mm x 130 mm
53 mm x 95 mm
END208-6
Intended use
The tool is intended for accurate straight cutting and
(only when used as a miter saw on the lower table)
miter cutting in wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
7
Miter angle
0°
right 69 mm x 85 mm, 93 mm x 67 mm
left 69 mm x 85 mm, 93 mm x 67 mm
right 35 mm x 91 mm, 49 mm x 67 mm
left 35 mm x 65 mm, 49 mm x 42 mm
530 mm x 476 mm x 535 mm
･
Only for EU countries
Do not dispose of electric equipment
together with
material!
In observance
Directive, on Waste
Electronic Equipment
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally
recycling facility.
LH1040 / LH1040F
255 mm - 260 mm
1.6 mm - 1.8 mm
2.0 mm
25.4 mm and 25 mm
30 mm
45°
40 mm
4,800
260 mm x 405 mm
14.3 kg
/II
household waste
of the European
Electric and
and its
compatible
ENE060-1
ENF002-2