Advertisement
1.4
Daily use
1.4.1
Operating panel
D
C
Fig. 2 Control panel hot–water modules
A. descaling indication
Will flash to show that the machine needs to
be descaled.
B. [–] button
Push button to change the values during
programming.
C. [+] button
Push button to change the values during
programming.
D. display
Displays the temperature of the water in _C.
1.4.2
Operation
1.4.2.1
Preparing hot water
1. Switch on the module.
– The boiler is filled and the water is heated
up.
– During the filling and heating process, the
temperature indication on the display
flashes.
2. Wait until the temperature indication stops
flashing.
The module is now ready for tapping of hot water.
1.4.2.2
Tapping hot water
1. Place a cup or jug under the tap and pull the
handle forward.
TIP
– The tap can be locked in the open position by
pushing the handle fully away from you
against the spring pressure.
2
version
1.0
A
B
1.5
Programming the
module
The operating panel is also used for programming
purposes.
During programming, the [–] button (B.) serves to
lower certain values, and the [+] button (C.) to
raise them.
P1 (temperature):
Setting the water temperature.
Can be set from 55_C to 3 degrees less than the
boiling point.
P2 (counter position descaling):
Setting the counter position, at which the
descaling signal
is to start flashing.
P3 (total):
Reading the total number of litres of water that
has run through the module.
Factory setting
P1
boiling temperature –4°C"
P2
3
1. Simultaneously press the [+] button () and the
[–] button (B.) to start the programming
mode.
2. Keep them pressed for about 10 seconds,
until P1 appears on the display.
3. Let go of the buttons.
– The value for P1 appears.
4. Adjust, if desired, the value.
5. Press both buttons once or twice, for a short
moment, to select the next P values.
6. Wait for about 60 seconds.
– The programming mode will automatically
be switched off, storing the set value.
ECopyright Bravilor Bonamat B.V.
Set by you
Advertisement
