Table of Contents
Advertisement
5-7-4. Factory Reset
5-7-5. HDD Sleep
You can make X30 HDD go to sleep mode by this setting. There are five (5) options like OFF, 10
Min, 20 Min, 30 Min and 1 Hour. During the selected time, if no access to HDD, the HDD goes
into sleep mode.
5-7-6. HDD format
※ NOTE: HDD Format function of the X30 does not support multi-partitioning. If you would like
to make two (2) partitions on the HDD we recommend this is done using your computer.
5-7-6-1. Brand New HDD (not partitioned HDD)
※ NOTE 1: X30 provides two kinds of file systems for hard disk format. One is NTFS, the other is
Linux file system. You may select one of them during hard disk format procedure.
※ NOTE 2: Linux file system is more stable, and speed is also faster than NTFS. The Linux
file system is recommended.
To restore changed values of
setup, select Factory Reset
and confirm with the OK
button.
※ For the X30 to wake up from HDD
sleep mode, it takes 3~4 seconds.
During this time, the X30‟s response
to the input signal from remote
control will be delayed.
① Install the HDD into the X30 and power it
ON.
② Go to System of SETUP, and select HDD
Format, as shown left.
③ You will be asked to select Linux or NTFS.
Select one of them.
④ It will start formatting process by itself.
⑤ X30 will reboot automatically.
33
Advertisement
Table of Contents
