X30 Purchased Without Storage; Hdd Installation; Hdd Format; X30 Purchased With An Internal Storage Installed - Cocktail Audio X30 Manual

2-4. X30 purchased without storage.

You need a 3.5" or 2.5" SATA hard disk or SSD, and install it into the X30 like below picture and
format it. For formatting of the installed storage into X30, please refer to the 5-7-6. HDD format
(Page 33)

2-4-1. HDD installation

【 TIP 1 】 X30 supports 3.5" or 2.5" SATA hard disk and solid state drive (SSD)

2-4-2. HDD Format

※ Refer to the 5-7-6. HDD Format (Page 33)

2-5. X30 purchased with an internal storage installed.

Check whether the storage is formatted, or not. If the storage is not formatted, please format it
according to the 5-7-6. HDD Format (Page 33)

3. Connection

3-1. Power connection

Connect power to the X30 via the power inlet and switch on the rear of the X30.

3-2. External devices Connection

Refer to the rear view on page 9. Various devices can be connected to X30 like below according
to your purpose.
Speaker Out terminal(8ohm) : Bookshelf speaker or floor standing (power load) speakers

Digital Out (Toslink, Coaxial, AES/EBU XLR) : External DAC, etc

Analog Out(RCA, R/L) : External amplifier, etc

FM Radio Antenna connector : FM Radio antenna

USB Host ports: WiFi USB dongle, external USB devices, etc

HDMI Out : External screen like TV, etc

12