Set Up Your Television - Bang & Olufsen BeoCenter 6–23 Reference Book

30
For information about how to fasten
and run the cables on the rear of the
television, refer to page 32.
For further information about the
socket panel, refer to page 34.

Set up your television

Handling your television
– Avoid placing your television in direct sunlight
or direct artificial light, such as a spotlight, as
this may reduce the sensitivity of the remote
control receiver. Also if the screen is overheated,
black spots may appear in the picture. These
spots disappear again, once the television cools
down to normal temperature.
– To avoid injury, use Bang & Olufsen stands or
brackets only.
– Make sure that the television is set up, placed
and connected in accordance with these
instructions.
– The television is developed for indoor use in dry,
domestic environments only. Use within a
temperature range of 10–40°C (50–105°F).
– Do not place any items on top of the television.
– Always place your television on a firm and
stable surface.
– Do not attempt to open the television. Leave
such operations to qualified service personnel.
Overview of socket panels
1 Cover for fastening bracket for the optional
stand and wall bracket. Pull out at the bottom
to remove the cover.
2 Main socket panel. Refer to page 34 for further
information.
3 Cover for main socket panel. Pull out at the top
and lift to remove.
4 Cover for camera and headphones sockets.
Push in to open, push again to close.
5 Clamp for cables. It is important that the cables
are lead through the clamp and tied with a
cable tier as the cables can otherwise be tugged
free of the sockets. Refer to page 32 for further
information.
If you have a motorised stand, leave enough space
around the television to allow it to turn freely. The
television can also be turned by hand.
1
2
3
4
5