Datalogic TC1200 Reference Manual page 128

5
ACK Character
This setting specifies an ASCII character to be used as the ACK character. Selections: a
character from NUL (0x00) to DEL (0x7F).
The ACK Character must be different from the NAK Character and must not
contain reserved characters (see
characters such as XON, XOFF, or host commands conflicts with normal
operation of these characters. 8-bit data is not recognized when the option
NOTE
Data Bits has been set as 7 Data Bits.
To set this feature:
1. Determine the desired character.
2. Use the Chart in
3. Go to page 39
Programming Mode.
4. Scan the barcode: SELECT ACK CHARACTER.
5. Scan the two hex equivalent characters from the keypad in
desired character in step 1 above.
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure.
NAK Character
This setting specifies an ASCII character to be used as the NAK character. Selections: a
character from NUL (0x00) to DEL (0x7F).
The ACK Character must be different from the NAK Character and must not
contain reserved characters (see
characters such as XON, XOFF, or host commands conflicts with normal
operation of these characters. 8-bit data is not recognized when the option
NOTE
Data Bits has been set as 7 Data Bits.
To set this feature:
1. Determine the desired character.
2. Use the Chart in
3. Go to page 40 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter
Programming Mode.
4. Scan the barcode: SELECT NAK CHARACTER.
5. Scan the two hex equivalent characters from the keypad in
desired character in step 1 above.
6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure.
116
Appendix C to find the hex equivalent for the desired character.
and scan the ENTER/EXIT PROGRAMMING MODE to enter
Appendix C to find the hex equivalent for the desired character.
TC1200 REFERENCE MANUAL
Appendix D). Setting to previously defined
Appendix B
Appendix D). Setting to previously defined
Appendix B
that represent the
that represent the