Geometry Controls - NEC MultiSync FE950+ FE950+ FE950+ User Manual

Red, Green, Blue: AccuColor Control System decreases or increases the
monitor's red, green or blue color guns depending upon which is selected. The
change in color will appear on screen and the direction (decrease or increase)
will be shown by the bars.
sRGB Mode: sRGB mode provides the suitable color managed picture image.
You can not change Red, Green and Blue colors individually.

Geometry Controls

Geometry Controls Menu
The Geometry controls allow you to adjust the curvature or angle of the sides of
your display.
Sides In/Out (pincushion): Decreases or increases the curvature of the sides either
inward or outward.
Sides Left/Right (pincushion balance): Decreases or increases the curvature of
the sides either to the left or right.
Sides Tilt (parallelogram): Decreases or increases the tilt of the sides either to the
left or right.
Sides Align (trapezoidal): Decreases or increases the bottom of the screen to be
the same as the top.
Rotate (raster rotation): Rotates the entire display clockwise or counterclockwise.
Tools 1
Moiré Canceler: Moiré is a wavy pattern which can sometimes appear on the screen.
The pattern is repetitive and superimposed as rippled images. When running certain
applications, the wavy pattern is more evident than in others. To reduce moiré, adjust
the level by using –/+ CONTROL buttons.
Basic Convergence: Aligns all three colors (R,G,B) to form a single color (white).
The purpose of this control is to ensure that a white line drawn on the screen is
as crisp and clear as possible.
• Use the Horizontal control to adjust the alignment of the white lines in the
up/down direction.
• Use the Vertical control to adjust the alignment of the white lines in the left/
right direction.
Corner Correction:Allows you to adjust the geometry of the corners of your
display — Top, Top Balance, Bottom or Bottom Balance.
GlobalSync ® Control: Eliminates picture impurities that may result from the
earth's magnetic field. While in the sub-menus (GlobalSync, Top Left, Top
Right, Bottom Left or Bottom Right), use the –/+ control buttons to fine tune the
GlobalSync corrections. Note: NEC recommends that you perform GlobalSync
correction while running a typical application such as a spreadsheet or text document.
Auto Save: The monitor automatically saves the last settings of the user controls.
You can turn this Auto Save feature off by selecting this menu and changing the
off position. When the off mode is selected, you will prompted with the option to
950+.wpc
–continued
6
8 1/2/01, 10:04 AM