Removing The Base; Specifications - NEC AccuSync LCD51VM User Manual

Non-abrasive surface
Figure R.1

Removing the Base

NOTE: Always remove the Base when shipping the LCD.
1. Place monitor face down on a non-abrasive surface (Figure R.1).
2. While using your thumbs, press the bottom tabs upward to unlock.
3. Press the top tabs down to unlock and pull off the stand.
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm.
Please use the attached screws (4pcs) as show in the picture when installing. To meet the safety requirements, the monitor
must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor.
The LCD monitor shall only be used with an approved arm (e.g. GS mark).

Specifications

01_English
Replace screws
75 mm (LCD51VM)
100 mm (LCD71VM)
4-SCREWS (M4)
(MAX depth: 8.5 mm)
If use other
screw, check
depth of hole.
Weight of LCD assembly: 2.6 kg - LCD51VM (MAX)
4
Figure R.2
75 mm (LCD51VM)
100 mm (LCD71VM)
4.0 kg - LCD71VM (MAX)
English-4
20/05/2003, 11:44
Figure R.3
Thickness of Bracket
(Arm) 2.0 ~ 3.2 mm
Tighten all screws