Problem Solving Guide; Check And Fault Messages - Miele T 7944 C Operating Instructions Manual

With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.

Check and fault messages

Problem
The programme stops
and 0 and Finish appear
in the display.
The buzzer sounds.
The Low temperature
indicator light starts
flashing after the dryer
has been switched on
and 0-§ appears in the
display.
The programme stops
and Cooling down or
Finish flashes in the
display.
The buzzer sounds.
Possible cause
This is not a fault.
The electronic unit has
recognised that there is
no laundry in the drum
and cancelled the
programme.
Drying individual
garments or items which
are already dry can also
cause the programme to
be cancelled.
The electronic system
lock is activated.
No obvious cause.

Problem solving guide

Remedy
– Use the Warm air
programme (timed
drying) to dry individual
items.
– To select a new
programme, switch the
dryer off and on, or
– Open the door, place
more laundry in the
drum, then close the
door.
You will need to
deactivate the system
lock before the dryer can
be used (see "Electronic
system lock").
– Switch the dryer off
and then on again.
– Then start the
programme again.
If the programme stops
again and Cooling down
or Finish flashes again,
there is a fault. Contact
the Miele Service
Department.
29