Pat Testing; Operation - Prem-I-Air EH0468 Instruction Manual

Do not use the appliance in locations where paint, petrol or other flammable
liquids are used or stored.
Always transport and store in an upright position.
Do not allow the appliance to fall over when there is water in the bucket.
When used in an office environment, this product must be safety-tested yearly by
a qualified electrician (PAT Tested) in order to comply with the Electricity at Work
Regulations.
We recommend that it is PAT tested regularly when used in a domestic
environment.
Leave the appliance in an upright position for 3 hours before first use.
Plug the mains lead into a 13 Amp mains socket (unless permanently installed)
If connecting via an extension lead, make sure that the lead is rated at 13 Amps
or more, and that it is fully unwound.
Switch the unit on at the mains socket.
ON/OFF Button: Press the "ON/OFF" button to start the unit. The Power
indicator illuminates when the appliance is ON. There will be a short delay (of
about a minute) before the appliance starts to operate.
"MODE" Button: Select the mode by pressing the "MODE" button. The available
modes are:
Automatic mode: either heats or cools as required to maintain the
selected room temperature. Then use the TEMP+ and TEMP˜ buttons to
select the desired room temperature. When the temperature reaches the desired
temperature, the compressor will stop, and the fan will continue to run.
Cooling mode: cools if the room temperature is above the selected
temperature.Then use the TEMP+ and TEMP˜ buttons to select the
desired room temperature. When the temperature reaches the desired
temperature, the compressor will stop, and the fan will continue to run.
Dehumidifying mode: removes humidity, but does not affect room
temperature. The fan operates at its lowest speed. For best results, do not
use the exhaust tube, but fit a permanent drainage pipe to the drain outlet as
shown on page 7.
Fan mode: circulates the air, but does not affect room temperature or
humidity.
Heating mode: heats if the room is temperature is below the selected
temperature. Then use the TEMP+ and TEMP˜ buttons to select the
desired room temperature. When the temperature reaches the desired
temperature, the compressor will stop, and the fan will continue to run. Heating
performance reduces if the outdoor temperature falls below 7 °C

PAT TESTING.

OPERATION

Page 4