Quick Start - NEC LCD17V User Manual

Quick Start

To attach the Base to the LCD Stand:
. Insert the front of the LCD Stand into the holes in the front of the Base (Figure 1).
2. Attach the Base to the Stand. The locking tab on the Base should fit into the hole on the
back of the Stand.
3. Attach the Cable Holder onto the Base (Figure 2). Insert the hooks on the Cable Holder
into the holes at the back of the Stand and slide the Cable Holder downward into
place.
Figure 
Stand
Locking Tab
To attach the LCD monitor to your system, follow these instructions:
. Turn off the power to your computer.
2. For the PC with Analog output: Connect the 5-pin mini D-SUB signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the MAC: Connect the Macintosh cable adapter to the computer, then attach the
5-pin mini D-SUB signal cable to the Macintosh cable adapter (Figure A.2). Tighten all
screws.
NOTE: To obtain the Macintosh cable adapter, call NEC Display Solutions
of America, Inc. at (800) 632-4662.
3. Connect one end of the power cord to the LCD and the other end to the power outlet.
Place the video signal cable and power cord between the cable holder (Figure B.1).
NOTE: Adjust the position of cables between the holder to avoid damage.
NOTE: If you use this monitor at AC25-240V, please refer to Recommended Use
section of this manual for proper selection of power cord.
4. Turn on the monitor with the front power button and the computer. (Figure C.1)
5. No-touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial
setup for most timings. For further adjustments, use the following OSM
• Auto Adjust Contrast
Refer to the Controls section of this User's Manual for a full description of these OSM controls.
NOTE: For download information on the Windows
your monitor, refer to the References section of this User's Manual.
NOTE: If you have any problems, please refer to the Troubleshooting section of this
User's Manual.
Front Base
• Auto Adjust
3
Figure 2
95/98/Me/2000/XP INF file for
®
controls:
®