Floppy Disk Problems; Display Problems - MAXDATA Vision 350M User Manual

Floppy Disk Problems

The floppy disk does not work properly-
n
n
n
The floppy drive does not save -
n
n
n
The diskette does not eject from the drive -
n
n

Display Problems

The display panel is blank when the system is turned on -
n
n
n
The screen is difficult to read -
n
n
Check the color indicator LED for FDD. When you access a
file, the LED lamp should light up momentarily.
The floppy diskette may be damaged. Try a different diskette
to see if the problem persists.
Check if the disk is fully inserted into the floppy drive.
Check if the tab of the floppy disk is on the write-protect
position.
Have the disk formatted.
If the disk capacity had been reached, use another disk or
remove the existing files to make room for the svaing file.
The metal cover on the diskette might be bent. Contact your
local dealer for technical support.
A label may became detached and is blocking the ejection
of the disk. Visually inspect slot to see if any obstruction
occurred by the label. Contact your local dealer for techni-
cal support.
Make sure the notebook is not in the Suspend or Save To
Disk modes. The display is turned off to conserve energy in
these modes.
Press Fn+F7 to increase the screen brightness.
Press Fn+F4 to make sure the notebook is not in the CRT-
output only mode.
Press Fn+F7 to increase the screen brightness.
The display resolution should be set to 1024x768 for optimal
viewing.
1. Go to [Start > Settings > Control Panel] and double-click
on the Display icon.
2. Under the Settings page, click the Adanced icon.
3. Under the Dispaly Modes page to set the resolution to
1024x768 and choose at least 256 colors.
Section 5 TROUBLE SHOOTING
5-7