Handling; Charging Battery; Using The Optional Ac Adapter (Ps-11) - Epson TM-P80 Technical Reference Manual

Handling

This chapter describes basic handling of the printer.

Charging Battery

Follow the steps below to charge the battery. You can charge the battery using the printer itself
with the optional AC adapter (PS-11) or using the optional multi-charger (OT-CH60II).
Be sure to use the battery OT-BY60II.
Using a battery other than the one specified may cause fire, explosion, leakage, overheat-
ing or other damage.
WARNING
 The battery can be charged only when the temperature is 0 ~ 40°C {32 ~ 104°F}.
 Dispose of used batteries according to the instructions.
 Do not remove the battery during charging.
 Fully charging a battery that is fully discharged while the printer is turned off will take
 Charging the battery at 35°C {95°F} or higher may require a longer charging time than
 You can use the printer during the battery charging.
 For information on the optional AC adapter (PS-11), see its User's Manual.
 For information on the optional multi-charger (OT-CH60II), see its User's Manual.

Using the optional AC adapter (PS-11)

1
Install the battery.
See "Installing the Battery" on page
2
Connect the optional AC adapter to the connector for the AC adapter.
Charging starts. The Charge LED turns on while charging the battery.
approximately 2.5 hours.
the specified one.
31.
Chapter 4 Handling
4
83