Dme Modification Kit - Sony DME-3000 Product Manual

SONY

DME Modification Kit

BKDM-3000K1 DME Modification Kit
34 • • Configuration Guide
This section describes the kit that is used to convert a DME-3000 to a DME-7000.
The BKDM-3000K1 DME Modification Kit provides the necessary hardware and
software for converting a DME-3000 to a DME-7000.
Because each DME-3000 system includes a different array of boards and options,
each upgrade is essentially a "custom" procedure. To achieve DME-7000 features
and picture quality, the upgrade consists of four components: a RISC CPU board,
Video Processing Board, Mother Board and Rear Panel assembly. Additional
boards may be required for advanced DME-7000 features.
As a prerequisite for upgrading, the customer should be prepared to provide the
sales representative with the following "checklist" items:
Provide DME-3000 serial number.
Provide current DME-3000 system configuration, including a list of all
input boards and optional effects boards resident in the system.
Provide current control panel and operating software configuration.
Please note the following important points:
•
The DME-3000's 3-D Linear Address Board MPU-70 does not need to
be upgraded.
•
All optional DME-3000 boards except the BKDM-3060 can be used in
the upgraded DME-7000 equivalent. The BKDM-7060 is
recommended.
•
For advanced DME-7000 features, the BKDM-7070 is required.
•
Modification on site is not recommended. Modification at the Sony
Service Center is recommended, and may be required.
•
Refer to the Field Service Upgrade Policy UPG-152 for complete
upgrade details and procedures.
•
If the customer's current software and hardware configurations are not
available, the customer or sales representative can contact Sony
SOFTWARE
•
For further assistance with system expansion and upgrading, please
contact your regional Product Specialist.
SM
for details on the customer's configuration.
PLUS
DME-3000/7000 • Product Guide