Buffalo AirStation WHR-HP-G54 Quick Setup Manual page 3

Step 2 - Connecting Cables to the AirStation
Ethernet cable to PC
AC power
1. Power down the Cable or DSL modem and the computer which will be used to
confi gure the AirStation router.
2. Screw external antenna on to top of AirStation.
3. Plug the Cable or DSL's LAN Ethernet cable into the AirStation's WAN port.
Initially, you may need to unplug this cable from your computer, hub or other
router.
4. Plug the provided Ethernet cable into a LAN port on the AirStation and plug the
other end into your computer's Ethernet adapter's (NIC) port. If you plan to
initially confi gure the AirStation wirelessly (not recommended), you may skip
this step.
5. Power on your cable or DSL modem and wait one full minute, then power on
the AirStation router (by plugging in its power) and wait another minute, and
fi nally power on the computer which will be used to confi gure the AirStation. If
the red DIAG light on the AirStation is lit or fl ashing after several minutes of
being powered on, please consult Buffalo Technology Technical Support.
Ethernet cable to
Cable/DSL modem
3