Buffalo WHR-HP-G300N Setting Manual

Hide thumbs Also See for WHR-HP-G300N:

Download this manual See also: User Manual

Enlarged version

WHR-HP-G300N Router Settings (For: HKBN, I-Cable, HGC DHCP User)

Hardware Setup of WHR-HP-G300N Router:

Set

Router

switch to "ON".

Power on Buffalo Router, and wait for 2 minutes.

The "Power", "Wireless" and "Router" indicators will be ON, and

"DIAG" will be OFF.

To reset the router, please insert "RESET" hole by a paper clip for about

10 seconds, and wait for 2 minutes. The "Power", "Wireless" and

"Router" indicators will be ON, and "DIAG" will be OFF.

Last Updated 28/11/2009

Hornington KB:

http://kb.hornington.com

4. Please connect your broadband service with a network cable (or from

cable modem) to the "INTERNET" port on the ROUTER. Then use

another network cable to connect "LAN1" port on the ROUTER to the

Ethernet adapter on your PC. Make sure indicators "INTERNET" and

"LAN1" near lan ports are ON.

For i-cable user, please power off modem for 1

modem again.

Wait for 2 minutes.

hour. Then power on

WHR-HP-G300N DHCP Settings Page 1

Page 1 WHR-HP-G300N Router Settings (For: HKBN, I-Cable, HGC DHCP User) 4. Please connect your broadband service with a network cable (or from Hardware Setup of WHR-HP-G300N Router: cable modem) to the “INTERNET” port on the ROUTER. Then use another network cable to connect “LAN1” port on the ROUTER to the Router switch to “ON”.
Page 2 WHR-HP-G300N Router Settings (For: HKBN, I-Cable, HGC DHCP User) Choose “Acquire an IP Address Automatically from a DHCP Server”, Launch Web Browser, enter http://192.168.11.1 in address bar and then And then click “Apply” to save settings. press Enter. Then type username as “root”,...
Page 3 WHR-HP-G300N Router Settings (For: HKBN, I-Cable, HGC DHCP User) 10. Click "Basic (11n/g/b)" Click “Wireless Config” Wireless Channel, choose a channel used for the router. Under page “WPS”, please UNCHECK “enable” option behind “WPS” In general, you are suggested to try channel 11, 6, or 1.
Page 4 WHR-HP-G300N Router Settings (For: HKBN, I-Cable, HGC DHCP User) 11. The orange “SECURITY” indicator will turn on to show the wireless Click "Apply" again to confirm network is secured. 12. Setting Completed Please write down the “Wireless Network Name” (SSID) “Wireless...