Installing A 5 1/4-Inch Accessible Device; Inserting A 5 1/4-Inch Device For Use In A Minitower - NEC PowerMate CT Service And Reference Manual

Installing a 5 1/4-Inch Accessible Device

Note
Install rails on the new device before attempting to insert the new device in the system.
Use the rails from the old device or the empty bay.
1. Remove the system unit cover and front panel (see "Removing the Cover" and "Removing
the Front Panel").
system power cable. Power is removed only when the power cable is unplugged.
2. If you are installing the device in an unused bay, remove the bay cover (see "Removing a
Bay Cover").
If the bay contains a device to be removed, remove the device (see "Removing a 5 1/4-Inch
Accessible Device").
3. If the new device does not already have rails on either side, use the rails from the empty bay
or from the old device (see "Removing or Installing Device Rails").
Position the new device so it is right-side up for the chassis orientation you plan to use (see
4.
the following figure).
(desktop or minitower) you plan to use. Make sure the device is right-side up for that
configuration.
Slide the device into the device cage in the chassis. The tab on the end of each rail should
5.
click into place when the device is in place.

Inserting a 5 1/4-Inch Device for Use in a Minitower

6. Reconnect the power and signal cables to the device.
7. Replace the front panel (see "Replacing the Front Panel").
Replace the system unit cover (see "Replacing the Cover").
8.
Before removing the cover, turn off system power and unplug the
Orient the 5 1/4-inch accessible device correctly for the configuration
Disassembly and Reassembly 3-23