Intended Use; Technical Data; Declaration Of Conformity - Bosch Rotak 32 Original Instructions Manual

OBJ_BUCH-1266-001.book Page 8 Tuesday, September 21, 2010 9:55 AM
8 | English
If in doubt contact a qualified electrician or the near-
est Bosch Service Centre.
WARNING! Inadequate extension cables can be
dangerous. Extension cable, plug and socket
must be of watertight construction and intended
for outdoor use.
Cable connections should be kept dry and off the
ground.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
For products not sold in GB:
WARNING: For your safety, it is required that the plug
attached to the machine is connected with the exten-
sion cord. The coupling of the extension cord must be
protected against splash water, be made of rubber or
coated with rubber. The extension cord must be used
with a cable strain relief.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if in
perfect condition.
If the supply cord is damaged, it must be replaced by
a Bosch Service Centre.
Products sold in GB only: Your product is fitted with
an BS 1363/A approved electric plug with internal fuse
(ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its
place by an authorised customer service agent. The re-
placement plug should have the same fuse rating as
the original plug.
The severed plug must be disposed of to avoid a pos-
sible shock hazard and should never be inserted into a
mains socket elsewhere.
Products sold in AUS and NZ only: Use a residual cur-
rent device (RCD) with a rated residual current of
30 mA or less.
Maintenance
Always wear gardening gloves when handling or
working near the sharp blades.
Keep all nuts, bolts and screws tight to be sure
that the machine is in safe working condition.
Check the grass catcher frequently for wear or de-
terioration.
Examine the machine and replace worn or dam-
aged parts for safety.
Ensure replacement cutting means of the right
type are used.
Ensure replacement parts fitted are Bosch ap-
proved.
Symbols
The following symbols are important for reading and
understanding the operating instructions. Please take
note of the symbols and their meaning. The correct in-
terpretation of the symbols will help you to use the
garden product in a better and safer manner.
Symbol Meaning
Movement direction
Reaction direction
Wear protective gloves
Weight
Switching On
Switching Off
Permitted action
Prohibited action
Accessories/Spare Parts
F 016 L70 769 | (21.9.10)

Intended Use

The garden product is intended for domestic lawn
mowing.

Technical Data

Lawnmower
Article number
Rated power input
Blade width
Height of cut
Grassbox, capacity
Weight according to
EPTA-Procedure 01/2003
Protection class
Serial number see type plate on the
garden product
The values given are valid for a nominal voltage [U] of
230 V. For different voltages and models for specific
countries, these values can vary.
Please observe the article number on the type plate
of your garden product. The trade names of the indi-
vidual garden products may vary.
Noise/Vibration Information
Measured sound values determined according to
2000/14/EC (1.60 m height, 1 m distance away).
Typically the A-weighted noise levels of the product
are: Sound pressure level 79 dB(A); sound power level
93 dB(A). Uncertainty K =1 dB.
Vibration total values (triax vector sum) determined
according to EN 60335:
Vibration emission value a <2.5 m/s
h
2
Uncertainty K =1.5 m/s .

Declaration of Conformity

We declare under our sole responsibility that the prod-
uct described under "Technical data" is in conformity
with the following standards or standardization docu-
ments: EN 60335 according to the provisions of the di-
rectives 2004/108/EC, 2006/42/EC, 2000/14/EC.
2000/14/EC: Guaranteed sound power level 94 dB(A).
Conformity assessment procedure according to
Annex VI.
Equipment category: 32
Notified body:
SRL, Sudbury, England, Nr. 1088
Technical file at:
Bosch Lawn and Garden Ltd., PT-LG/EAE,
Stowmarket, Suffolk IP14 1EY, England
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
04.08.2010
Mounting and Operation
Action
Delivery Scope
Handle Assembly
Snap together the Grassbox
Grassbox fitting/removing
Adjusting the Cutting Height
Connecting the Extension Lead
Starting
Stopping
Working Advice
Blade Maintenance
Selecting Accessories
Rotak 32
3 600 H85 B..
W 1200
cm 32
–
mm 20 60
l 31
kg 6.6
II
/
2
,
Figure
1
2
3
3
4
5
5
5
–
5 6
7
7
Bosch Power Tools