Panasonic WH-SD24BE5 Operating Instructions Manual page 6

ADVANCE OPERATION ADVANCE OPERATION
Recommendation Recommendation
• It is strongly recommended to have the authorized dealer to change the water temperature range. The temperature range
for water outlet temperature and outdoor ambient temperature could be set by control panel.
Perform the steps below to set preferred temperature range.
2 4
,
STEP 1: Press
STEP 2: Press
H2O Lo: Water outlet set
temperature at low outdoor
ambient set temperature
H2O Hi: Water outlet set
temperature at high outdoor
ambient set temperature
Out Lo: Low outdoor
ambient set temperature
Out Hi: High outdoor
ambient set temperature
Note: Please make sure High outdoor ambient set temperature (Out Hi) is always higher than Low outdoor
ambient set temperature (Out Lo).
STEP 3: After selecting the desired parameter, press
parameter is selected.
STEP 4: Press
STEP 5: Press
• Repeat steps 2 to 5 to set other parameters.
CANCEL
• Press or wait 30 seconds to exit SETTING mode.
• The setting temperature will be stored in the system once confi rm.
• "SETTING" mode cannot be activated when the "PUMPDW" and "STATUS" indicator is ON.
6
SET
for 5 seconds to enter SETTING mode. "SETTING" indicator is ON.
or to choose a parameter.
or to set the desired temperature.
SET
again to confi rm the setting.
SETTING STATUS
SET CHECK
SELECT
ERROR
CANCEL
RESET
HEAT
HEAT
HEAT
HEAT
SELECT
to enter the parameter. "
SEARCH
PUMPDW
Selection range:
25°C ~ 55°C
C
SETTING
STATUS
PUMPDW
Selection range:
25°C ~ 55°C
C
SETTING
STATUS
PUMPDW
Selection range:
-15°C ~ 15°C
C
SETTING
STATUS
PUMPDW
Selection range:
-15°C ~ 15°C
C
SETTING
STATUS
PUMPDW
" indicator will blink when a
1 5
,
3