Assembly And Adjustments - Hitachi B 16RM Instruction Manual And Safety Instructions

ASSEMBLY AND ADJUSTMENTS

ESTIMATED ASSEMBLY TIMES 20~40 MINUTES
ASSEMBLY INSTRUCTIONS
WARNING
For your own safety, never connect plug to power
source outlet until all assembly and adjustment steps are
completed, and you have read and understood the safety
and operating instructions.
WARNING
The Drill Press is very heavy and MUST be assembled
with the help of 2 PEOPLE OR MORE, to safely assembly
it.
COLUMN SUPPORT TO BASE (FIG. A)
1. Position the base (1) on the fl oor.
2. Place the column (2) on the base, aligning the holes
in the column support with the holes in the base.
3. Locate the four long hex bolts (3) from the loose parts
bag.
4. Place a bolt in each hole through the column support
and the base. Tighten with an adjustable wrench.
Fig. A
3
INSTALLING THE TABLE (FIG. B and C)
1. Locate the table crank handle (1) and support lock
handle (2) from the loose parts bag.
2. Insert the support lock handle from the left to right into
the hole (3) at the rear of the table support assembly.
Tighten by hand.
3. Install the table crank handle (1) onto the small shaft
(4), aligning the set screw (5) with the fl at surface
of the shaft (4). Tighten the set screw with a hex
wrench.
4. Loosen the support lock (2). Raise the table arm
5. Place the table (6) in the table arm assembly. Tighten
INSTALLING BATTERY FOR LASER GUIDE (FIG. C-1)
2
1. Open the cover of battery box.
2. Install 2 pieces of 1.5V 3A batteries into the battery
1
3. Close the cover.
4. Turn on the switch to check the LASER GUIDE.
NOTE: Replace the batteries with batteries that have
a rating of 1.5 volts (Number 4 series and AAA size
or equivalent). When replacing the batteries, the
battery guide should be thoroughly cleaned. Use a soft
paintbrush or similar device, to remove all sawdust and
debris.
— 11 —
Fig. B
assembly by turning the crank handle (1) clockwise.
Tighten the support lock. (Fig. C)
the table lock handle (7). (Fig. C)
Fig. C
6
7
box.
Fig. C-1
English
2
3
4
5
1
2
1