Specifications; Specific Safety Rules; Functional Description - Makita TD0101 Instruction Manual

ENGLISH
1. Switch trigger
2. Lamp
3. Reversing switch lever
4. Bit
5. Sleeve
6. Bit-piece
7. Standard bolt

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute (min
Max. fastening torque
Dimensions (L x W x H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to impact
driver safety rules. If you use this tool unsafely or
incorrectly, you can suffer serious personal injury.
1. Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring or its own cord.
Fasteners contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Wear ear protectors.
4
Explanation of general view
8. Fastening torque
9. Fastening time (S)
10. Proper fastening torque
11. High tensile bolt
12. Limit mark
13. Screwdriver
14. Brush holder cap
Model
Machine screw
Standard bolt
High tensile bolt
-1
)
-1
)
Net weight
Safety class
SAVE THESE INSTRUCTIONS.
ENE033-1
WARNING:
MISUSE or failure to follow the safety rules stated in
ENF002-1
this instruction manual may cause serious personal
injury.

FUNCTIONAL DESCRIPTION

CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
GEB012-3
Switch action (Fig. 1)
CAUTION:
• Before plugging in the tool, always check to see that
the switch trigger actuates properly and returns to the
"OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
Lighting up the lamp (Model TD0101F
only) (Fig. 2)
CAUTION:
• Do not look in the light or see the source of light
directly.
Connect the plug to light up the lamp. The lamp keeps on
lighting while the plug is connected.
15. Screw
16. Hook
17. Groove
18. Bumper
19. Hammer case cover
TD0101/TD0101F
4 mm - 8 mm
5 mm - 14 mm
5 mm - 10 mm
0 - 3,600
0 - 3,200
100 N•m
184 mm x 67 mm x 192 mm
0.99 kg
/II