Activate/Deactivate The Collar; Operation; Changing Operating Modes - EYENIMAL SMALL BARK CONTROL User Manual

Diagram 2

Activate/Deactivate the collar

Activate: move the magnetic key towards the collar so that it comes into contact with the
symbol, hold for 1 second (See Diagram 3). A Beep sound will be emitted and the indicator light
will flash in green (1 flash every 5 seconds) indicating that the collar has been switched on.
Deactivate: move the magnetic key towards the collar so that it comes into contact with the
symbol, hold for 1 second (See Diagram 3). Two beep sounds will be emitted and the indicator
light will flash in red twice and then off indicating the collar has been switched off.
To increase the battery life, we recommend you to deactivate the collar if you are not using
it for a long period.

Operation

At the first bark, a beep sound is emitted. If another bark is detected within 30 seconds, another
beep sound is emitted together with a static stimulation (stimulation for sensitive dog or difficult
dog according to the selected operating mode).
Inhibition of any further stimulation is dependent on the absence of any barking within the next
30 seconds.
The stimulation function can be inhibited selecting operating mode Nr 1. In this case, only beep
sounds will be emitted.
After being activated 9 times in quick succession, the collar will automatically go into safety
mode for 2 minutes before restarting itself normally.

Changing operating modes

In the factory, the collar is set to mode Nr 2 (beep sound + progressive stimulation for sensitive
dog).
To change the collar's mode, proceed in the following way:
- When switching on the collar, keep the magnetic key in contact with the
of the collar (See Diagram 3).
Gb - 16
Diagram 3
symbol on the front