Error Log - Nautilus TREADCLIMBER TC916 Owner's Manual

CONSOLE COdES
4
review error log and reset service timer
1. To review the error log and reset the service timer, press [Speed: UP], [7],
[ENTER]. The console will display "MAINTENANCE LOGS". Press [Speed: UP]
or [Speed: DOWN] to scan through the choices. Select the option you want
by pressing [ENTER].

error log

To display the machine's error log, press [ENTER] when the message, "ERROR LOG",
is displayed. The console will report various error messages in the display window.
The total amount of errors will be displayed in the upper right window. Note that
only the highest priority reported error will be displayed. Errors are handled in two
ways. First, as a non-fatal "WARNING" which will display the text message but
continue system operation until you press the [CLEAR] key. The second way is a
fatal "ERROR" which will stop the exercise and return the system to an idle intensity
state. The console will display the error text and not let you restart the program
unless power has been turned off and then back on.
reset service time
To reset the time between service or maintenance calls, press [ENTER] when
the message, "MAINT HOURS" is displayed. Selecting this code will reset the
maintenance timer to 0 hours.
2. To exit "MAINTENANCE LOGS", press the [CLEAR] key.
configuration codes
1. To change the machine type from "TREADMILL" to "TREADCLIMBER",
press [Speed: UP], [8], [ENTER]. The console will display
"CHANGE MACHINE". Press [ENTER] again.
2. Press [Speed: UP] or [Speed: DOWN] to scan through the choices. Select the
option you want to view by pressing [ENTER].