Specifications - Makita JV0600 Instruction Manual

ENGLISH (Original instructions)
1-1. Cutting action changing lever
2-1. Switch trigger
2-2. Lock button
3-1. Speed adjusting dial
4-1. Blade holder
4-2. Blade
4-3. Fixed position
4-4. Released position
5-1. Blade clamp lever
6-1. Wrench holder
6-2. Hex wrench
7-1. Cutting line
7-2. Base

SPECIFICATIONS

Length of stroke
Max. cutting capacities
Strokes per minute (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for the sawing of wood, plastic and
metal materials. As a result of the extensive accessory
and saw blade program, the tool can be used for many
purposes and is very well suited for curved or circular
cuts.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
9-1. Hex wrench
9-2. Bolt
9-3. Base
10-1. Edge
10-2. Graduation
11-1. Base
11-2. Hex wrench
11-3. Bolt
12-1. Starting hole
15-1. Hose
16-1. Rip fence (Guide rule)
17-1. Bolt
17-2. Fence guide
Model
Blade type
Wood
Mild steel
-1
)
Overall length
Net weight
Safety class
) : 85 dB(A)
pA
) : 96 dB(A)
WA
ENE019-1
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : cutting boards
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENF002-1
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
4
17-3. Hex wrench
17-4. Rip fence (Guide rule)
18-1. Threaded knob
18-2. Pin
18-3. Rip fence (Guide rule)
18-4. Fence guide
19-1. Rip fence (Guide rule)
20-1. Anti-splintering device
20-2. Tool base
21-1. Cover plate
21-2. Tool base
JV0600
23 mm
B type
90 mm
10 mm
500 - 3,100
236 mm
2.4 kg
/II
2
) : 10.5 m/s
h,B
2
2
) : 5.5 m/s
h,M
2
ENG900-1
ENG901-1