Care For Your Range; Porcelain Enamel Finish; Hinged Top; Removable Oven Door - Hotpoint RGB524 Use And Care Manual

r—-–––
,.%!
~or
C are
of
the Continuous
4
c
roper care and
cleaning are
.~~~$ipportant so your Range will give
'-%uefficient and satisfactory ser-
vice. Follow these directions and
directions on the Cleaning Chart
page 20 carefully in caring for
your range.
...
bnaimei F!rlisl-1
:='lj;'@#:~ z
The porcelain enamel finish is
sturdy but breakable if misused.
This finish is acid resistant. How-
ever, any acid foods spilled (such
as fruit juices, tomato, or vinegar)
should not be permitted to remain
on the finish.
, ,.
~-~ j .rj < g ~ "~Top
.
4
cooktop 'which makes cleaning
easy and fast. To lift, grasp
bottom of front edge of cooktop
just above control panel and lift
up. Raise the support rod and set
under front edge of top. To lower,
lift top slightly and return support
rod to its down position, then
gently lower top into position.
REMEMBER: Burner grates must
be removed prior to lifting
cooktop.
.-..— ....- ...... ........-——--.——— .-—— .—— . ...... .
The oven door is removable for
cleaning. Be sure oven door is
fully cooled before removing. To
remove, open the door approxi-
mately 3" to the "special" stop
position. Grasp the door on each
side and lift straight up and off the
hinges. DO NOT IMMERSE THE
OVEN DOOR IN WATER. Clean
as described in Cleaning Chart on
page 20.
To replace door, position slots in
bottom of door over the hinges
that are in the "out" position, then
lower door slowly and evenly over
both hinges at the same time. If
hinges are not "out", simply pull
the hinges to open position
to
replace door.
The bottom panel of the oven may
be removed to clean. pe sure
oven is fully cooled, then lift front
of panel and gently remove from
oven. Clean with mild soap and
water. Dry with soft cloth. Replace
by placing back of bottom in oven
first and then lowering front into
position.
Owen
Light
When replacing oven interior light
bulb, be sure oven is completely
cool. DISCONNECT POWER TO
RANGE by unplugging range, or
by removing fuse or throwing cir-
cuit breaker. Then make towel
into a ball and by applying pres-
sure and turning, bulb should be
unscrewed easily. Always handle
bulb with a dry (never wet) cloth
to protect hands. Unscrew bulb
and replace.
1
I
I
0