National Instruments Isolated Analog Input Device NI PXI-4224 User Manual page 67

Removing the NI PXI-4224
Note You must physically remove the NI PXI-4224 from the chassis before you can
remove it from MAX.
Removing the NI PXI-4224 from a PXI or PXI/SCXI
Combination Chassis
© National Instruments Corporation
This appendix provides details for removing an NI PXI-4224 device from
MAX and from a PXI or PXI/SCXI combination chassis.
Consult the PXI or PXI/SCXI chassis documentation for additional
instructions and cautions. To remove the NI PXI-4224 device from a PXI
or PXI/SCXI chassis, complete the following steps while referring to
Figure C-1:
1. Power off the PXI chassis. Do not remove the NI PXI-4224 device
from a chassis that is powered on. If the you are using a PXI/SCXI
combination chassis, also power off the SCXI portion of the chassis.
2. Rotate the mounting screws that secure the NI PXI-4224 to the chassis
counter-clockwise until they are loose, but do not completely remove
the screws.
3. Remove the NI PXI-4224 by pushing down steadily on the
injector/ejector handle until the device disengages from the chassis.
4. Slide the device completely out.
The next time you restart the computer the NI PXI-4224 will have a red
circle with a white X inside it next to the device in MAX.
C-1
C
NI PXI-4224 User Manual