Selecting An Area Of Stimulation; Setting The Intensity - schwa-medico EMP 4 PRO Instruction Manual

9
schwa-medico EMP 4 PRO

Selecting an area of stimulation

Depending on the selected program you can choose between upper and lower limbs. The
body symbol on the display is half colored, depending on the selected limbs. The pulse
width is increased for lower limbs.
Press the key to select the area of stimulation.
Programs with a possibility of upper and lower limbs stimulation:
P1 - P4, P6, P17, P21 - P26, P32, P38, P40 - P47, P49 - P60

Setting the intensity

Start the stimulation by increasing the intensity with the ▲ key of the channel(s) connected
to the electrodes.
Alternatively you can increase the intensity of all four channels simultaneously by pressing
the "4 +" key. You can then adjust the intensity of each channel by using the ▲ and ▼
keys.
You increase the intensity with the ▲ key.
You decrease the intensity with the ▼ key.
The intensity of each channel is displayed on the screen. The intensity can be set between
0 and 100 mA.
Setting the intensity of agonist/antagonist program (P37 and P67):
When you are using agonist/antagonist programs (P37 and P67), first set the intensity of channel
1 and 2 and then set the intensity of channel 3 and 4.
Active channels are identified by flashing intensity values.
If the intensity of all channels is not changed over a three seconds period, the device starts
with the agonist/antagonist stimulation. Please note that the stimulation is alternating
between channel 1 and 2, respectively 3 and 4.
If you are stimulating with dynamic programs (P56 to P60 and P65 to P66) or agonist/
antagonist programs (P37 and P67), active channels are identified by flashing intensity
values.