Specifications - Audio Technica ATW-R1810 Installation And Operation Manual

Specifications

UHF Operating Frequencies
Band C:
Band D:
Band E:
Band F:
Number of Operating Frequencies
Frequency Stability
Modulation Mode
Normal Deviation
Operating Range
Operating Temperature Range
Frequency Response
Receiving System
Image Rejection
Signal-to-Noise Ratio
Total Harmonic Distortion
Sensitivity
Audio Output (balanced)
Output Connector
E
Monitor Headphone Output (typical)
N
Monitor Headphone Jack
External Power Requirements
Batteries (not included)
Current Consumption (battery)
Battery Life
Dimensions
Net Weight (without batteries)
Accessories Included
RF Power Output
Spurious Emissions
Dynamic Range
Input Connections
Batteries (not included)
Current Consumption
Battery Life
Dimensions
Net Weight (without batteries)
RF Power Output
Spurious Emissions
Dynamic Range
Input Connector
Microphone Power
Batteries (not included)
Current Consumption
Battery Life
Dimensions
Net Weight (without batteries)
† Specifications are subject to change without notice.
†
541.500 to 566.375 MHz
655.500 to 680.375 MHz
795.500 to 820.000 MHz
840.125 to 864.875 MHz
996 total per band (25 kHz increments)
±0.005%, Phase Lock Loop frequency control
FM
±10 kHz
100 m (300') typical
-5 °C (23 F) to 45 °C (113 F)
70 Hz to 15 kHz
Dual independent RF sections,
automatic-switching diversity
>50 dB typical
104 dB at 30 kHz deviation (A-weighted),
maximum modulation 37 kHz
<1% (±10 kHz deviation at 1 kHz)
25 dBµV, (S/N 60 dB at 5 kHz deviation, A-weighted)
27 mV (at 1 kHz, ±5 kHz deviation)
3- pin mini XLR (TA3M-type)
35 mW max., 32 ohm load
3.5 mm TRS, signals on both Tip and Ring
12V DC nominal, 500 mA
Four 1.5V AA alkaline
315 mA typical
10 hours typical,
depending on battery type and use pattern
75.0 mm (2.95") W x 125.0 mm (4.92") H x 32.0 mm (1.25") D
300 grams (10.5 oz)
Two flexible UHF antennas; one 18" TA3F to XLRM
output cable; belt pouch
High: 30 mW; Low: 10 mW, nominal
According to R&TTE 1999/05/EC Directive
>105 dB, A-weighted
High impedance, low impedance, bias
Two 1.5V AA alkaline
High: 180 mA; Low: 160 mA, typical
Approximately 6 hours (High); 8 hours (Low),
depending on battery type and use pattern
66.0 mm (2.60") W x 87.0 mm (3.43") H x 24.0 mm (0.94") D
80 grams (2.8 oz)
High: 30 mW; Low: 10 mW, nominal
Under federal regulations
>105 dB, A-weighted
3-pin locking XLRF-type
Provides power to condenser microphones rated to
operate on 12V phantom power or less.
Two 1.5V AA alkaline
High: 180 mA; Low: 160 mA, typical
Approximately 6 hours (High); 8 hours (Low),
depending on battery type and use pattern
40.0 mm (1.57") x 111.0 mm (4.37") x 40.0 mm (1.57")
199 grams (7.0 oz)
Overall System
ATW-R1810 Single-channel Receiver
ATW-T1801 UniPak ™ Body-pack Transmitter
ATW-T1802 Plug-on Transmitter
15