Metabo BST 9.6 Operating Instructions Manual page 10

8090.book Seite 10 Donnerstag, 23. Mai 2002 2:49 14
ENGLISH
ENG
5 Overview
Refer to page 3 (Please fold out).
1 Rapid-action keyless chuck
2 Selector barrel (4)
(torque, drilling, impact drilling)*
3 Cordless power tool
4 Slide-switch (1st/2nd gear)
5 Slide-switch for impulse mode*
6 Battery-pack release button
7 Battery pack
8 Depot for screwdriver bits
9 Trigger-switch
10 Slide-switch (rotational direction setting,
transporting safety feature)
*depending on equipment
6 Special Product Features
Metabo impulse mode (depending on equip-
ment).
Makes driving in and unscrewing tight-seated
screws child's play, even if the screw head is
damaged.
For rapid, clean-edged drilling, with no need for
centre-punching - into tiles, aluminium or other
materials.
7 Operation
Charge the battery pack before use.
Only once it has been charged and discharged
five times (charging cycles) does the battery
pack reach its full charging capacity.
The temperature range for charging is 0 - 50°C.
The number of possible charging cycles varies
depending on the particular charger in use.
• CS 10: max. 3000
• C 25: max. 2000
• C 60: max. 2000
However, the specified number of charge
cycles is only reached if an exhaustive
discharge of the battery pack is avoided. If
performance diminishes, recharge the battery
pack. The battery packs have no memory
effect.
Store charged NiMH battery packs and
recharge them after an interval of no more than
six months.
10
7.1 Removing and replacing the battery-
pack
Removing
Press in the release button (6) and remove the
battery pack (7).
Replacing
Push the battery pack (7) fully into its housing
until it locks into position.
7.2 Setting the direction of rotation enga-
ging the transporting safety device
(switch-on lock)
Do not operate the slide-switch (10)
unless the motor is at a standstill.
Position the slide-switch (10) as required:
R = right-hand rotation selected
L = left-hand (reverse) rotation selected
0 = central setting: transporting position
(switch-on lock engaged)
7.3 Selecting gear
Do not operate the slide-switch (4)
unless the motor is at a standstill.
Position the slide-switch (4) as required:
= 1st gear (low speed, exceptionally high
torque)
= 2nd gear (high speed)
7.4 Setting torque control, drilling,
impact drilling
Twist the selector barrel (2).
1 = minimal torque setting
(with torque control)
drill setting
impact drill setting
(depending on equipment)
7.5 Switching impulse mode on and off
(depending on equipment)
Do not work with impulse mode swit-
ched on over an extended period of
time (the motor is liable to overheat).
Position the slide-switch (5) as required:
0 = Impulse mode switched off
• = Impulse mode switched on