Connecting Signals - National Instruments Single-Ended Digital Waveform Generator/Analyzer Modules NI SMB-2163 User Manual

Connecting Signals

Connections that exceed any of the maximum ratings for the NI SMB-2163
Caution
or the NI digital waveform generator/analyzer can damage the device and the computer.
Maximum input ratings are provided in the specifications document that shipped with the
NI digital waveform generator/analyzer. NI is not liable for any damages resulting from
such signal connections.
NI SMB-2163 User Guide
The NI SMB-2163 provides connectivity to up to 32 single-ended DIO
channels, three programmable function interface (PFI) channels, and
two clock channels of an NI digital waveform generator/analyzer. You
can connect to these signals from the labeled SMB connectors on the
NI SMB-2163.
Figure 3 shows the pinout of the DDC connector of the accessory. Each
DIO, PFI, and clock channel is connected to a corresponding pin on the
NI SMB-2163.
Table 1 describes the DDC signals in the pinout.
6 ni.com