Audible Tones; Table 6: Audible Tones - Bosch D1260 Installation Manual

.
2.2.4

Audible Tones

The D1260/D1260B Keypad has a built-in speaker that produces several distinct warning tones. The user can
change the speaker volume and display brightness to meet their needs. You cannot connect external annunciation
devices to the D1260/D1260B. Anytime the D1260/D1260B emits an audible tone, the keypad illuminates.
Silence the audible tones in Table 6 by entering a programmed passcode with the appropriate authority, or
[COMMAND] + [4] unless otherwise noted.
Table 6: Audible Tones
Tone
Fire Signal
Burglary Signal
Entrance Warning
Exit Warning
Invalid Key Buzz
Keypad Encoding Tone
Trouble Buzzer
Watch Tone
Bosch Security Systems | 9/04 | 48101E
D1260/D1260B | Installation Guide | 2.0
Description
When an area is in fire alarm, the keypad emits a pulsed, high-pitched bell tone.
When an area is in alarm, the keypad emits a steady, high-pitched bell tone.
The keypad emits an intermittent beep tone during entry delay periods to remind the user to
disarm the area. This is a programmable option.
The keypad emits an intermittent beep tone during exit delay. This is a programmable option.
When an invalid key, or sequence of keys, is pressed, the keypad emits a flat buzz tone.
The keypad emits a muted beep tone as each key is pressed to indicate that the entry was
accepted. To disable this feature, refer to Section 3.2 Setting the DIP Switch on page 10.
When a trouble event occurs, such as a service alert, the keypad emits a two-tone warble until
you enter [COMMAND] + [4].
When you activate the Watch feature ([COMMAND] + [6]), a single clean tweedle tone alerts
the user anytime a watch point is faulted. This option is programmable by point. To disable the
Watch Feature, press [COMMAND] + [6] again.
D1260/D1260B Overview
7