Rane RPM 26z Quick Start Manual

Rane RPM 26z Quick Start Manual

Programmable multiprocessor

Advertisement

Quick Links

RPM 26z
PROGRAMMABLE MULTIPROCESSOR

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RPM 26z and is the answer not in the manual?

Questions and answers

Summary of Contents for Rane RPM 26z

  • Page 1 RPM 26z PROGRAMMABLE MULTIPROCESSOR...
  • Page 2: Important Safety Instructions

    • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. CAUTION: Changes or modifications not expressly approved by Rane Corporation could void the user's authority to operate the equipment. This Class B digital apparatus complies with Canadian ICES-003.
  • Page 3: Quick Start

    IP address should appear under the Live folder in the ning with your sleek new RPM 26z. If you don’t read the entire Project window. If a device does not appear, consult Drag Net’s Hardware Manual, at least read this section.
  • Page 4: Front Panel Description

    Front Panel Description RPM 26z PROGRAMMABLE MULTIPROCESSOR LOCK INPUT AES3 OUTPUT PRESET ETHERNET STATUS POWER 5 6 7 1 Signal/Overload LED meters indicate the presence of significant audio signal or overload for Inputs and Outputs. These 3-color meters indicate the available headroom once the analog signal has been converted to digital: -4 dBFS (red, near clipping), -12 dBFS (yellow, high normal level), and -48 dBFS (green, low level).
  • Page 5: Audio Connections

    96 kHz. Sample rates ex- Digital Trim control located immediately after the A/D con- ceeding the RPM 26z’s internal 48 kHz sample rate are automat- verter. ically downsampled. Word lengths up to 24-bits are accepted.
  • Page 6: Ethernet Control

    All devices connected to the Ethernet port, including repeater hubs, switches, and the computer’s Network Interface Card (NIC) must support 10Base-T communication. ©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5000 USA TEL 425-355-6000 FAX 425-347-7757 WEB www.rane.com Manual-4 111216...
  • Page 7 Select a device type, RPM 26z for example, and specify a hard drive stor- Transfer configurations between Storage and Live by dragging and age location to create a new configuration.
  • Page 8 Preset change; all other full scoop. blocks maintain their current set- The Remote Interface Port uses Rane's RW 485 protocol to tings, thereby creating a parameter communicate with our SR series of Smart Remotes. Double-click overlay effect. The Preset window...
  • Page 9 The Resource Window displays usage information specific to the hardware device you're working with. The DSP usage meter indicates the amount of DSP "horsepower" used by the current configuration, and is always accurate. There is no need to hit a “compile”...
  • Page 10 Preset. Clear these tags by right-clicking within the Device Configuration window and selecting Clear all preset tags. ©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5098 USA TEL 425-355-6000 FAX 425-347-7757 WEB www.rane.com Drag Net Quick Start-4 106405...

Table of Contents