ASROCK 748-M User Manual page 24

Peripheral Configuration:
OnBoard FDC
OnBoard Serial PortA
OnBoard Serial PortB
Serial PortB Mode
OnBoard Parallel Port
Parallel Port Mode
EPP Version
Parallel Port IRQ
Parallel Port DMA Channel
OnBoard Midi Port
Midi IRQ Select
OnBoard Game Port
OnBoard IDE
OnBoard LAN
OnBoard AC' 97 Audio
F1:Help
Esc:Previous Menu
OnBoard FDC: Use this to enable or disable floppy drive controller.
OnBoard Serial PortA: Use this to set the address for the serial port COM1.
Configuration options: [Auto], [Disabled], [3F8 / IRQ4 / COM1],
[2F8 / IRQ3 / COM2], [3E8 / IRQ4 / COM3], [2E8 / IRQ3 / COM4].
OnBoard Serial PortB: Use this to set the address for the serial port COM2.
Configuration options: [Auto], [Disabled], [3F8 / IRQ4 / COM1],
[2F8 / IRQ3 / COM2], [3E8 / IRQ4 / COM3], [2E8 / IRQ3 / COM4].
Serial/Infrared Switch: The default value of this item is [Serial PortB]. If it
OnBoard Parallel Port: Select Parallel Port address or disable Parallel Port.
Configuration options: [Auto], [Disabled], [378], [278].
Parallel Port Mode: Set the operation mode of the parallel port. The
OnBoard Midi Port: Select address for Midi Port or disable Midi Port.
Configuration options: [Disabled], [330], [300], [290], [292].
Midi IRQ Select: Use this to select Midi IRQ.
OnBoard Game Port: Select address for Game Port or disable Game Port.
Configuration options: [Disabled], [200], [208].
OnBoard IDE: You may enable either the primary IDE channel or the secondary
IDE channel. Or you may enable both the primary and the secondary IDE
channels by selecting [Both]. Set to [Disabled] will disable the both.
Configuration options: [Disabled], [Primary], [Secondary], [Both].
2 4
AMIBIOS SETUP UTILITY - VERSION 3.31a
Advanced
Peripheral Configuration
:Select Item
is set to [Serial PortB], COM2 port will be activated and the onboard
infrared header (IR1) will be disabled. If it is set to [Infrared Port], the
onboard infrared header (IR1) will be activated and COM2 port will be
disabled.
default value is [ECP+EPP]. If this option is set to [ECP+EPP], it will
show the EPP version in the following item, "EPP Version".
Auto
Auto
Auto
Normal
Auto
ECP+EPP
1.9
Auto
Auto
Disabled
5
200
Both
Enabled
Auto
+/-:Change Values
Enter:Select Sub-Menu
[ Setup Help ]
<Enter> to enable or
disable the floppy
drive controller.
F9:Setup Defaults
F10:Save & Exit