Daikin BRC1E51A7 Installation Manual page 5

To avoid leakage and electric shock due to entry of water or insects, fi ll the wiring through hole with
putty.
To avoid electric shocks, do not operate with wet hands.
Do not wash the remote controller with water, as this may result in electric shocks or fi re.
Install the indoor and outdoor units, power cord and connecting wires at least 1 meter away from
televisions or radios to prevent picture interference and noise.
(Depending on the incoming signal strength, a distance of 1 meter may not be suffi cient to eliminate
noise.)
Do not install the air conditioner in the following locations:
1. Where there is a high concentration of mineral oil spray or vapour (e.g. a kitchen).
Plastic parts will deteriorate, parts may fall off and water leakage could result.
2. Where corrosive gas, such as sulphurous acid gas, is produced.
Corroding of copper pipes or soldered parts may result in refrigerant leakage.
3. Near machinery emitting electromagnetic radiation.
Electromagnetic radiation may disturb the operation of the control system and result in a
malfunction of the unit.
4. Where fl ammable gas may leak, where there is carbon fi bre or ignitable dust suspensions in the
air, or where volatile fl ammables such as paint thinner or gasoline are handled.
Operating the unit in such conditions may result in fi re.
5. High temperature area or directly fl amed point.
Heating and/or fi ring may be caused.
6. Moist area, or place where may be exposed to water.
If water enters inside of the remote controller, electric shock may be caused and inner electronics
may fail.
When remote controller thermo function is used, select the installation location considering the
followings.
● A place where average temperature in the room can be detected.
● A place where is not exposed to direct sunlight.
● A place where is far apart from heat source.
● A place where is not affected by outside air due to door opening/closing or the like.
English
CAUTION
3