Lighting Instructions - Napoleon CSS610RB Owner's Manual

LIGHTING INSTRUCTIONS

Open lid.
Ensuring all burner controls
are in the off position,
slowly turn on the gas
supply valve.
Main Burner Lighting
Push in on any main burner
knob and turn to "HI". A
click should be heard from
the valve, sending a spark
to light the pilot flame.
If ignition is not immediate,
turn burner control off.
Wait 5 minutes.
If the burner will not light
after several attempts, it
can be lit by inserting a lit
extended match or lighter
through the cooking grids
to the burner. Push the
knob in and turn to "HI".
The propane cylinder is equipped with an excess flow device. Unless all burners are turned
off prior to turning the cylinder on, only small flames and low heat will be achievable.
LEFT
BURNER
CENTRE
BURNER
REAR
RIGHT
BURNER
BURNER
Rear Burner Lighting
Remove warming rack.
(the excess heat will
cause the rack to warp.)
Push the knob and hold
for approximately 5
seconds before rotating.
This allows gas to reach
the rear burner. Rotate
the knob to "HI" and press
the igniter button.
If ignition is not immediate,
turn burner control off.
Wait 5 minutes.
If the burner will not light
after several attempts, it
can be lit by holding a lit
extended match or lighter
against the burner. Push
the knob in and turn to "HI".
REAR BURNER IGNITER