Napoleon High Country NZ6000 Installation And Operating Instructions Manual page 17

CONNECTION
The Napoleon Model
NZ6000 may be
connected to either a
lined or unlined
masonry chimney.
IF THE CHIMNEY
IS LINED,
the flues
must be made of
vitrified clay and be in
sizes of 8" square or
8" round (inside
diameters) or 8"x12"
with a minimum
height of 15 feet
above the fireplace.
Eight inch round flues
are recommended.
Installation must
conform to both
national and local
code requirements.
IF THE CHIMNEY IS UNLINED,
listed to either Standard ULC-S640M in Canada or UL-
1777 in the USA: Liners for New Masonry Chimneys, may
be used to connect the fireplace to the chimney. The liner
must be continuous from the fireplace to the chimney cap
and be installed only per manufacturers instructions. In
both cases, the chimney structure must be supported by
angle iron anchored into the masonry walls. The allow-
able masonry used in chimney construction is 3-1/2" brick,
solidly mortared and fully encasing the flue. Ensure there
are no leaks.
In no case is the masonry enclosure to be supported
by the NZ6000 fireplace. Allow a 1" (one inch) air cavity
for expansion.
TO A MASONRY CHIMNEY
a stainless steel liner
HI-TEMP GASKET
For a masonry fireplace use a flue tile support. For a pre-
fabricated chimney use an anchor plate.
ANCHOR PLATE
FIREPLACE TOP
FLUE TILE SUPPORT FOR A MASONRY FIREPLACE
FIREPLACE TOP
17
W415-0594 / A / 02.15.07